CyberPower PDU20SW8RNET Instrukcja Użytkownika Pobierz pdf (Strona 117)

115

 Severity & Category: The events can be filtered by category and severity. The events can be further divided by

Power Event and System Event categories, and choosing the specific event. When any event option is selected

from the event list, the logs only related to this event will be displayed.

 Max. logs: Indicates the maximum number of events that will be displayed.

 Type: Selects the event log whose type is system, group or device.

 Keywords: Each event log whose detail contains this keyword will be filtered out.

Security

Please refer to Security/Login section about how to configure Account and Session settings.

Authentication

The Center uses the secret phrase and SNMP protocol to secure and protect network communication between Agent,

Client and the devices. The security settings on Security/Authentication page in the Center must be configured.

If the Center establishes the communications with below devices, refer to Secret Phrase section.

 A computer running Agent and Client.

 UPS RMCARD202 and higher version.

 PDU whose mode is not PDU20SW8RNET or PDU15SW8RNET

If the Center doesn’t interact with aforementioned application and devices, refer to SNMP, SNMPv1 and SNMPv3

sections for further details.

PowerPanel

Secret Phrase. Center can interact with Agent, Client, UPS RMCARD and PDU by using the secret phrase to create

secure communication. The default phrase is powerpanel.encryption.key. The Secret Phrase can be configured on

the Security/Authentication page in the PowerPanel

Applications, or on the System/Security page in the PDU and

UPS RMCARD web. The Secret Phrase which is used in the PowerPanel

Applications, PDU and UPS must match.

Note: If the firmware version on the RMCARD202 is earlier than 1.1, you should refer to SNMP Community and

SNMP Trap Community sections for the correct configurations.

SNMP

The Center can interact and access device information via SNMPv1 and SNMPv3. Fewer early UPS and PDU models

which only accept SNMPv1 demands and newer models which support SNMPv3 can be controlled by Center.

SNMP Protocol: User can determine which SNMP protocol to use over the network communication between Client

and devices. It is recommended to choose Both option because Client attempts on the correct SNMP protocol for

device to interact.

SNMPv1

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 132 133

Brak uwag

CyberPower PDU20SW8RNET Instrukcja Użytkownika Strona 117