CyberPower PDU20SW8RNET Instrukcja Użytkownika Pobierz pdf (Strona 93)

 Environment Sensor: Indicates whether the environment sensor has been installed on the UPS/PDU/ATS. Note:

When the sensor cannot be detected anymore, it will be annotated No Response. Users can click the Uninstall to

reflect it if it had been removed physically from the UPS/PDU/ATS.

Status

The Status tab displays details about the UPS/PDU/ATS.

 Current: The output current in Amps.

 Outlets: The status of each outlet on the UPS/PDU/ATS and the name of the connected computer or equipment.

 Input: Displays the status of the utility power supplied to the UPS.

 Voltage: The voltage of the utility power supplied to the UPS.

 Frequency: The frequency of the utility power supplied to the UPS in Hertz.

 Output: Displays the status of the output power that is being supplied to connected equipment.

 Load Consumption: The power draw of the connected equipment expressed as a percentage of the total load

capacity. This displays as watts on some UPS models.

 Battery: Displays the status of the battery packs.

 Capacity: The capacity of the batteries, expressed as a percentage of full charge.

 Remaining Runtime: The estimated amount of time that the UPS can supply power to its load.

 System: Displays the operating status of the UPS.

 Environment Temperature: Indicates the measured temperature from the environment sensor.

 Environment Humidity: Indicates the measured humidity from the environment sensor.

 Contact: Indicates generic equipment connects to this sensor. Users can define the name and state in RMCARD

web for each contact and monitor the state is normal.

 Source A Voltage: The voltage of the input power supplied to the source A of ATS.

 Source B Voltage: The voltage of the input power supplied to the source B of ATS.

 Load: The power draw of PDU/ATS supplying power to connected equipments.

 Bank # Load: The power of the PDU/ATS bank supplied power to the connected equipments.

Information

Information tab shows information about the UPS/PDU/ATS.

 Type: The type of the device, such as On-Line, Line Interactive or Sinewave Line Interactive for UPS; or

Monitored or Switched for PDU/ATS.

 Model Name: The model name of the UPS/PDU/ATS.

 Firmware Version: The firmware version of the UPS/PDU/ATS.

 MAC address: The MAC address of the UPS RMCARD, PDU or Agent computer's network interface.

 Serial Number: The serial number of the UPS.

Note: This will give the internal serial number on some models.

 Power Rating: The Volt-Amp rating (VA) and power rating (Watts) of the UPS.

 Voltage Rating: The output voltage rating (Volts) of the UPS.

 Frequency Rating: The output frequency rating (Hz) of the UPS.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 132 133

Brak uwag

CyberPower PDU20SW8RNET Instrukcja Użytkownika Strona 93