CyberPower PDU15SW8RNET Instrukcja Użytkownika Pobierz pdf (Strona 22)

PowerPanel™ Business Edition

 Bypass: The UPS has switched to bypass mode and the utility power is being supplied directly to

the connected equipment bypassing the UPS circuitry.

Note: Bypass mode is only applicable in Online Series UPS units.

 No Output: There is no output from the UPS. The UPS is switched off.

 Short Circuit: There is a short circuit on the UPS output. This causes the UPS to stop supplying

output power.

 Boost: The utility voltage is below the regular voltage range. The UPS is increasing the output

voltage closer to normal.

 Buck: The utility voltage is beyond the regular voltage range. The UPS is decreasing the output

voltage closer to normal.

Note: The Boost and Buck function are only available on a UPS with AVR. The UPS uses the AVR

function to improve the utility voltage and supplies the power to its connected equipment within a

narrow range.

 Overload: The present load exceeds the load threshold of the UPS. Remove some equipment from

the UPS to reduce the load.

 ECO Mode: On-line UPS enters Economy mode. The UPS will enter bypass mode according to

thresholds for input voltage. Once the utility voltage exceeds thresholds, the UPS will supply battery

power to its loads.

 Manual Bypass: The Online UPS enters Manual Bypass mode due the Manual option being

enabled. The UPS will be forced to provide utility power to its equipment.

z Voltage: The output voltage that the UPS is supplying to the connected equipment.

z Frequency: The output frequency that the UPS is supplying to the connected equipment.

z Load: The power draw of the connected equipment expressed as a percentage of the total load capacity.

This is displayed as watts on some UPS models.

z NCL Outlet: Displays the present status of the NCL outlet.

 On: This outlet is turned on and supplying power to the connected equipment.

 Off: This outlet is turned off and is not supplying power to the connected equipment.

 Pending On: This outlet is going to turn on following an action such as a scheduled turn on.

 Pending Off: This outlet is going to turn off following an action such as a scheduled turn off.

Battery

z Status: Displays the present status of the battery packs.

 Fully Charged: The batteries are at 100% capacity.

 Discharging: The UPS is supplying battery power to support the load. This is caused by a utility

power failure or battery test.

 Charging: The batteries are charging.

 Capacity Critically Low: The battery capacity is too low and the UPS may shut down immediately.

 Not Present: There are no batteries present in the UPS.

 Testing: The UPS is performing a battery diagnostic test. See the UPS/Diagnostics

page for more

details about the test results.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 99 100

Brak uwag

CyberPower PDU15SW8RNET Instrukcja Użytkownika Strona 22