CyberPower PDU15SW8RNET Instrukcja Użytkownika Pobierz pdf (Strona 92)

PowerPanel™ Business Edition

}

Set both minimum_font_size and minimum_logic_font_size to 10 in order to display the pages

normally. Save the preference file and launch the Chrome again to access PPBE software.

8. The PPBE software cannot send WLM notifications in case of power events.

z The account which is used to send WLM notifications may be not available. Using the Verify button

on the Windows Live Messenger block to verify the account details is recommended.

z The account which is used to receive WLM notifications may be not available. Using the Test button

of the WLM account field to verify is recommended.

z The port 1863 used by the WLM service on PPBE software may be blocked by a firewall.

9. The shutdown occurs earlier than expected time.

It may be caused by the following conditions:

z When batteries have been used for a long time, they are unable to reach a full charge. Check to see

if the output load is too high. A high load on the UPS will cause the batteries to discharge faster and

the remaining runtime quickly decrease. Disconnect some load from the UPS to reduce the load in

order to extend the runtime.

z Verify that the batteries are fully-charged. If the capacity is too low, please charge the batteries to full

capacity.

10. Pages cannot be displayed after I set up another port number in the Security/Network page.

The port that was set up in the Security/Network page may be occupied by other applications or

services. This indicates that the pages can’t be accessed through the assigned port. Follow below steps

to continue accessing the Agent/Client/Center web:

z Find the webserver.xml file located at <Installation_directory>/etc/agent folder on the Agent

computer or <Installation_directory>/etc/client folder on the Client computer.

z Use the text editor to open the webserver.xml and you can find the <httsPort> tag in the file as

below example:

<?xml version=”1.0” encoding=”UTF-8” standalone=”yes”?>

<httpsMode>ENABLE</httpsMode>

<httpsPort>port_number</httpsPort>

</webServer>

Change the port of the <httpsPort> and make sure that the port is not occupied by other services or

applications. Save the webserver.xml file. (httpsNumber is numeric from 1 - 65535)

Note: The default port number is 53568.

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 98 99 100

Brak uwag

CyberPower PDU15SW8RNET Instrukcja Użytkownika Strona 92